GRZ

 

Product name:	Particle filtering half mask
Model:	GR202
Manufacturer:	Guangdong GangRong Medical Technology Co., Ltd
Address:	Floor 2, Block 13, Building 2, No. 68, Zhenxing Road, Dabu village, Sanxiang Town, Zhongshan City
Tel:	18022083537
Email:	99322575@qq.com

Failure to follow the instructions and warning on the use of this mask during all times of exposure can reduce the effectiveness of the mask and could result in illness or disability.

 

A copy of the Declaration of Conformity for this product can be found on the product page:http://www.gdgrmt.com/

 

As with any respiratory device, the wearer must be adequately trained prior to use. Before use, the wearer should always check the mask is in good condition- no dirt, no damage to headharness attachment etc

 

These particulate respirators are designed to protect against solid and non-volatile liquid particles.

Check before use.

 

Do not use the respirator or enter or stay in a contaminated area under the following circumstances:

  a Atmosphere contains less than 19.5% oxygen.

  b If you smell or taste contaminant.

  c For protection against gases or vapors.

  d Contaminants or their concentrations are unknown or immediately dangerous to life or health.

  e For sandblasting, paint-spray operations and asbestos treatment.

  f In explosive atmospheres.

 

1 This mask marked “NR”, shall not be used for more than one shift.

2 Never substitute, modify, add, or omit parts in the configuration as specified by the manufacture.

3 This mask helps protect against certain particulate contaminants but does not completely eliminate exposure to the risk of contracting disease or infection.

4 It is unlikely that the requirements for leakage will be achieved if facial hair passes under the face seal.

5 Change the mask immediately if breathing becomes difficult or the mask becomes damaged or distorted.

6 Change the mask if a proper face seal cannot be achieved.

 

 

1 Hold the particle filtering half mask in position over the nose and mouth.

2 Pull lower strap over the head and fit around the back of the neck.

3 and pull the upper strap over the head positioning it just above the ears.

4 Ensure the nose clip is securely moulded around the nose, resting the ends against the cheek to obtain a good seal.

5 To check for proper fit, cup both hands over the mask and exhale vigorously. If air leaks around the nose, tighten the nose clip, if air leaks around the edge, reposition the headharness for better fit.

6 Repeat adjustments until the mask is sealed properly.

7 If a proper seal cannot be achieved do not enter the contaminated area or it may cause illness.

1 Store the mask in a sealed container away from contaminated areas when not use.

2 Store the mask in the original packing during transport.

Marking

Notified body: CCQS Certification Services Limited.

Address: Block 1 Blanchardstown Corporate Park, Ballycoolin Road, Blanchardstown, Dublin15, D15 AKK1, Ireland (NB 2834).

Manufacturer: Guangdong GangRong Medical Technology Co., Ltd

Address:Floor 2, Block 13, Building 2, No. 68, Zhenxing Road, Dabu village, Sanxiang Town, Zhongshan City